How to make terracotta hanging pots

Looking for something unique, handcrafted and affordable to decorate your home? Presenting some lovely handcrafted or hand painted decor products made by artists with passion and a whole lot of creativity!

This set of 4 terracotta hand-painted pots, highlighted with gold, makes for a very attractive decor item in your house. You can use it as a decorative hanging or with artificial plants. The pots can be hung in same or different levels by adjusting the strings attached. The colors used are water safe.

Who says the mosaic look can be achieved only through broken tiles! Here is a nice way to get the same look on your pots and keep your surroundings bright. This set has 4 hand painted terracotta pots which are 9 cm in height, 10 cm in width and 130 gm in weight each. This simple hand-painted beautiful hanging can be used to decorate both your interiors or exteriors, as the colours used are water safe. This can be a beautiful colourful addition to your garden greenery or monotonous interiors or can spruce up the patio area. These pots can also be used as planters.The pots can be hung in same or different levels by adjusting the strings attached, as per your choice.

Source

Source

DIY: Hanging plant pots made from old rags

beautiful hanging plant pots made from old rags 1

Flowers in hanging pots – it’s always nice. Especially well planter look, decorated with macrame technique. To make such a decoration, do not need to be at needlework. If you have unwanted rags suitable color and free 30 minutes, the case is almost done.

Necessary:

1.knitted fabric
2. tailor meter
3. Scissors

Let’s start:

Lay the fabric on a flat surface.

We have 8 strips on three centimeters wide. The length of strips depends on how long should be potted. The girl in the photo uses inches and cut the strips at 40 centimeters in length. Stretch the strip. The result should look like this. First, tie all the strips into one big knot. Tighten properly. Now divide the beam into four pairs. Measure out about 5 cm from the main unit and fasten by nodules on each pair. Do not tighten too tight – you can do so when the pot is inside. Now, again, divide the strips into pairs and tie knots, to get here are the diamonds. Repeat over and over again, departing at 5 centimeters from the previous node. For a small pot, as in these photos, it will be enough three levels. When macrame ready, put into the pot. If you like the nodules are located, you can tighten them tighter. Now the upper edge can be tied in a knot. Make sure the pot is hanging straight. Done! The color and length can be different.Elementary and very beautiful!