How to make beautiful elegant flower scrap of watercolor paper

elegant flower scrap of watercolor paper 1

You see what a wonderful and elegant work! Luxury flower scrap of watercolor paper – the fruit of creativity of talented seamstresses Sony, co-author of the scrap project Education For Stampers & Cardmakers, Germany. I propose to look at the flower production and note how the image of the flower, depending on the use of different molds. Enjoy watching!

Stage humidification paper blanks

Without waiting for drying, forming petals

Make a papier-mache cow using an empty water bottle and toilet paper rolls – Step By Step

cow 01 1

Required Material:
Two big plastic bottles, the more rigid the better
4 toilet paper tubes
Shoelace for the tail
Cocktail straws for the udder
Wooden toothpicks
Knife, scissors, and all
Crafts glue
Paint and brushes
And a lot of old newspapers
1. First of all, let’s make the tail. Pierce a hole in the bottle’s bottom, thread a shoelace through it so that its end reaches the bottleneck and tie a knot there. Then pull the knot inside the bottle.

Tie another knot outside the bottle, as close to the bottle as you can (the second knot isn’t shown in the photo). Add a crumpled piece of a newspaper to the outer part of the bottom if needed, secure it using masking tape. Masking tape is used widely in paper-mache because you can glue paper easily onto it.

The rear part of the cow looks like this:

2. I used a bottle with a special shape to make the neck, but your cow can be without a neck at all, that’s OK. You have only to make ears and snout. You might also want to add two horns if you like. For the snout remove the bottle’s neck to get a little bit wider opening.

Fold a thick strip of newspaper and roll it into a tight “snail”. Leave a short loose end.

Secure the snail with a piece of masking tape, and insert its end into the opening. Attach it with another piece of tape.

3. The ears can be made from another bottle. Leave a small rectangle at one end of each ear when you cut it out, then make two slits in the head and insert the rectangles into the slits.

Using this trick I wanted to create the right shape and rigidness for the paper mache ears.

This is how the head looks like when done.

4. Toilet paper tubes wanted to be cow’s legs, and we let them.

Make two semicircular cuts one opposite the other at one end of the tube where it will be connected to the bottle.

Attach the tubes using masking tape.

In this photo, you can see a leg with a hoof, the tail, and the udder. So, let’s make the udder.

5. We are about to make treats out of drinking straws (pink ones:)

Crumple a small ball from a newspaper, then make a U from a straw and pierce two holes in the places where it bends. Insert toothpicks through these holes and stick them into the paper ball.

Cut the toothpicks if needed. Make another pair of teats and attach the rudder to the body. The horizontal part of U will be covered with paper.

6. It’s time for papier-mache layers. We had 6 to 7 layers of pieces of newspaper dipped into craft glue mixed with water. Use a stronger glue mixture and white newspaper margins for the upper layers. You might want to check out other Web resources for basic and advanced papier-mache techniques, for example Getting Started with Papier Mache.

7. Decorate your cow, paint or glue a pair of eyes. That’s it.

DIY How to make origami peacock

origami peacock 1

We need:

  • blue 1253;
  • green 678,
  • yellow 371,
  • rose 93;
  • Total: 2395.
  • The size of the modules 1/32.

Let’s start with the body.
Putting 2 rows of 10 modules, make a chain.

3 series of 20 moduley.Odevaem way (picture shown in a different color). 4,5,6,7,8,9y ranks dress ….. 20 modules in each row. In a series of dress 10 m 3 modules typically ray of a 2 by 2, 3, usually 2 2 ray of, etc. It turns out 25 pieces. in the row. 11,12 and 13 in the series of 25 modules, 14th series of dress 18 modules, 14 ray of reserve.
Next to these 18 dress 17 modules, and then again 18, then 17 and 18y number again 18 modules, 19 series of 17 modules, 20y- 18 modules.
I do so, leaving a hole in the trunk for hvosta.Vy and can not bother to wear until the 21st series of 25 modules. 21 and 22 series in 30 moduley.Vot so looks a hole in the trunk. 23rd series of dress one ray of module 3, poluchaetsya 20 modules ryadu.Po middle one pink dress. In the 24m row 1 module pink dress pink 2, the other 18 blue. 25th number 1 pink, 19 sinih.Odevaem way.
Our body is ready. We proceed to the neck.
Putting 4 ryada.V first row of 8 modules, a second series of 9 modules, the third row again 8 modules, the fourth series of 9 modules, the center 1 pink. 7th series of 10 blue. 8th series of 8 blue, 1 pink.
9th number 10 blue.
10th series of 8 blue, 1 pink.
11th number 10 blue.
12th series of 8 blue, 1 pink.
13th number of the first module of a three ray of the second, too, three ray of 4 module typically, 7th module as well as the first ray of a three and three-eighth ray of. Thus, among the leaves 8 modules. 14th number again reducing, 1 pink dress in the usual way and 4 blue on the sides of each ray of three. Leaves 5 pieces in a row. 15th number 6 blue dress as usual.
16th number 1 pink, 4 blue.
17th number 6 blue.
18y number 1 pink, 4 blue.
19y number 6 blue.
20th number 1 pink, 4 blue.
21y number 6 blue.
22nd row 1 pink, 4 blue.
23rd number 6 blue.
24y number 1 pink, 4 blue. 25th series make the cut, 4 blue dress. 26th number 1 pink in the center, 2 blue on the sides.
27y number 4 blue.
28y number 1 pink, 2 blue.
29y number 4 blue.
30th number 1 pink, 2 blue.
31y number 4 blue.
32nd number 1 pink, 2 blue .
33rd number 4 blue.
34th number 1 pink, 2 blue.
35th row 4 blue. 36th series of pink in the center, 2 extreme dress every 3 luchika.Takim way out in a series of 3 shtuki.Sverhu on them in the middle, 2 blue dress.
Neck ready. Now head.
Take the 13 units, 13 more top dress, but the short side of the module naruzhu.Kazhdy better prokleivat. holding the edges to turn out blank. The third and fourth series of 13 pieces each. In the fifth row we add 4 modulya.Odevaem 3 modules as usual, 2 modules in the ray of 2, 3, as usual, the ray of 2 to 2, etc. At the other photo shows tsvetom.Vyhodit 17 pieces in a row. In a series of 8 blue 6m modules, 1 green, 7 blue, 1 green. The 7m number 2 green, 7 blue, 2 green, 6 blue. In the 8th row 1 green, 1 pink, 1 green, 6 blue, 1 green, 1 pink, 1 green, 5 blue. 9th row 2 green, 3 blue, 1 yellow, 3 blue, 2 green, 6 blue,
10th number 1 green, 3 blue, 2 yellow, 3 blue, 1 green, 7 blue;
11th series of 3 yellow, the other blue;
12th series 4 yellow;
13th series of 5 yellow;
14th series go to umenshenie.Odevaem 4 yellow, every ray of module 3, blue dress like obychno.Vyhodit 15 pieces in a row. 15th row 5 yellow, 2 blue dress on the sides as usual, and 4 blue dress from the bottom every 3 luchika.Vyhodit 13 pieces in a row. And the last, 16th ryad.Odevaem yellow 4 modules, each ray of 3, 7 as the blue obychno.Golova gotova.Oformim later) We proceed to the tail.
Collect 3 ryada.V the first 19 units, the second series of 18 modules, the third 17 units.
!!! Each module prokleivat PVA better, but in this case the tail once, during assembly, it is necessary to curve shape. 4th series of 18 yellow. 5th row 1 blue, 1 yellow, 3 green, 1 yellow, 3 green, 1 yellow, 3 green, 1 yellow, 3 green, 1 yellow, 1 blue. 6th row 1 blue, 1 yellow, 2 green, 2 yellow, 2 green, 2 yellow, 2 green, 2 yellow, 2 green, 1 yellow, 1 green siniy.Mezhdu a pink paste. 1 blue, 1 yellow, 2 green, 1 yellow, 1 blue, 1 yellow, 2 green, 1 yellow, 1 blue, 1 yellow, 2 green, 1 yellow, 1 blue, 1 yellow, 2 green, 1 yellow, 1 blue . 1 blue, 1 yellow, 1 green, 1 yellow, 2 blue, 1 yellow, 1 green, 1 yellow, 2 blue, 1 yellow, 1 green, 1 yellow, 2 blue, 1 yellow, 1 green, 1 yellow, 1 blue . 1 blue, 2 yellow, 1 blue, 2 ray of missing, again one blue, etc. on top of the yellow dress one yellow, one on each side of the blue. Top two blue on them one by one. Make peryshki.Odevaem 1 blue, 1 green, 1 blue, 2 on top of the blue, 1 green on them. Next to the green, one blue dress on a blue ray. Top two green and blue on the sides as in the previous ryadu.Sverhu one yellow to green, flanked by the green and one blue. Top 2 green, next to the blue. Next 1 green, next to the blue and top them sinih.Delaem 2 of 3 more. Now green peryshki.Odevaem one module 2 blue green, then one again, 2,1,2,1,2. Dress 2 green yellow and one on each side of the green, then yellow, and the top two on the sides of the green. In the center of the blue near yellow, flanked by two blue zelenye.Sverhu next yellow on the sides of the green. Then dress the center 1 pink, next to blue, then yellow and sides zelenye.Sverhu 2 blue, 2 yellow, 2 green, then blue 1, 2 yellow, 2 zelenyh.Posle 2 yellow, 2 green above 1 yellow, 2 green , 2 green top and the top 1 of 4 zelenyy.Delaem. Nearby peryshki.Odevaem 2 blue, they are green, two blue, green, 2 blue, green. On each side of the green 2 blue, 2 green on, 2 blue, above the yellow, 2 green, 2 blue, 2 green on, 2 blue, still above the green and 2 blue, 2 blue above, the uppermost one of siniy.Delaem 3. On the lower two feathers that in the center, dress 2 blue, 1 green, 2 blue, 1 green. Making 4 arochki.V one arch modules 5 on one side, five on the other and one in the center. Top blue dress. In the center of a pink dress 1, 2 above zelenyh.Posle 1 yellow, 2 green, then 2 yellow, 2 green after 1 pink, 2 yellow and 2 green. Then, on top of 2 yellow, 2 green above 1 yellow, 2 green, 2 blue, 2 green after 2 blue, then 1 green, 2 blue, 2 blue and on the tip 1 siniy.Takih 3 pieces. And here is our little tail)) That’s all detali.Prikleivaem beak, eyes, hoholok.Soedinyaem all parts with Thermo) Our peacock 🙂