DIY: Glowing garland with balls of yarn

On the eve of the New Year, I would like to tell you how I make a garland with balls of yarn.

We do this usually with his son. He most likes to burst balloons after they glue dries.

Here is a garland presented to me in the new year my sister.

Materials we need:

– PVA glue, better than plain. I use this:

Garland. I buy them in Ikeja. The Chinese are not suitable as light bulbs on them very much, and a small distance between them. Well and reliability again. This garland on batteries. She has a huge advantage: you do not get attached to the outlet. It can be hung wherever you want; – balloons. The smallest that can buy. I buy them just a big package, it is cheaper. More to come  but pharmacies they have gone missing;

Thread should be cotton, or not impregnated with glue, and the design does not turn solid.

The thickness you choose to your liking. Remember you need only one thing: the thinner the yarn, the denser should be winding. With a thicker thread than Iris ball can be more filigree.

Everything has its little secrets. And for them, I’ll tell you.

Inflate balloons. We try to make them round.

In the future, when winding thread can be slightly adjusted form.

If you want to relieve yourself a little further their effort to extract from the finished balls burst balloons before they can be wound a little grease or vegetable oil or fat cream. But there is a BUT. Is wound in such a case, the thread will be more difficult, since they will slide over the ball. In general, with such a small amount of oil to put optional, but if you want to make a big ball, then this procedure, you can not avoid, because otherwise, it will necessarily when you pop the balloon.

We perform in a plastic container two holes thick needle.

There is also a nuance. The needle must not be much thicker filament. If the hole will be a very large, then the thread is too wet, the glue will flow down your arms. If the hole is too small, then the thread will be almost dry and the ball does not get strong.

Fill the glue in the container and begin to wind thread the beads. The winding should be dense, but too drag is not necessary because the ball will turn rough. Once dry the balls ready for several hours. The bigger, the better. Threads should not be just dry, but firm. If much can not wait, you can dry the hair dryer.

Then comes the long-awaited and most favorite moment! Bursting balls !!!

That’s what we’ve got: After that, everything is very simple. We put in the small gaps between the thread bulb garlands. For reliability can be secured with hot glue. Install the batteries and come up with your child a place for garlands!

Because of thread and glue, you can do a lot of interesting things. Shades and just beautiful things

 

Leave a Reply

Your email address will not be published. Required fields are marked *