How to Make Toilet Paper Roll Holder from Plastic Bottle

This toilet paper holder made of plastic bottle.

I took a photo from all angles so that
You can see how it was done.

But, I … I’m curious, I decided to make one!
And as I have bottles to the mountains,
I got stuck at work.
Let’s go to the materials you will need to get started:
3 pet bottles
1 screw
1 pliers
1 pilot pen
1 ruler
String
I chose the bottle of Fanta because her body
Is longer and the middle of the bottle is
Suitable for cutting. I took the toilet paper and
Me to make the hits on the sides. Medi and I’m doing the lateral cut. I was measuring the little holes with a ruler.
In this case, I did with 1 cm away,
But this is not a rule.
Each one can do closer or
Further … as you wish. Please note that I made a cut for the roller attachment.
At least what I use is very chubby
And had to make the cut. With the help of the pliers, I got a screw
That allows me to drill the hole and not go straight through
plastic. But be careful when handling! Look at the holes.
I did them well on the that I did with the pen! Here I start to finish my work.
I preferred to do the string.
Although I have other lines, I thought the
String wedged well with plastic. I started the base with low buttonholes. Here the work is finished.
I also made a flower in colored string
And a leaf to give grace! To make the union of the plastic again, I made
In the weeds, with this, the increase necessary to
Fit the toilet paper properly. Here the details of the side.
And do not worry about the holes.
After finishing, you can not even see them.
The tip is to make the holes well on the edge,
And that I only realized after
I began to make the point.
I passed the first career with 3 points high
And 2 chains, and in the second race I made high points on high points, when I arrived in the fan I put
2 high points within space.
So filled it out and it was really cool!

courtesy: madame-kathia