How to make cheap frame

Good day to all. Today I want to show you how I make the scope of the paper tubes to their panels. Who is interested in a nice view

We need:

  • Paper A 4
  • PVA glue
  • Thermo gun
  • twine natural
  • clothespins
  • scissors
  • spoke
  • varnish (pictured there)
  • stain (in the photo is not present)

The sheet cut into two parts and twist the tube at an angle of 45 degrees. Tip with maximum precision sizing glue gun. If this is not done carefully when you’re painting the stained tubes, it does not lie flat. Here’s what happened This is one side of the frame. There should be 4.

When you add duct alternate thick and thin tip. To obtain a clean strip width. Overturn the tube glue tip top. Cut small strips of paper. And we stick to our paper tubes. Fasten duct clothespins most densely pressing them to each other, until completely dry. Done Doing these 4 and cover their stain. dry them Then place a layer of varnish 2 3 sushi Dried strips of the thermal glue gun to our panel. Like this With a sharp knife or scissors, cut off the ends. Between the gun, tubes Apply a thin strip of glue and glue quickly our splits. The tips are clipped. Glue gun our top and bottom of the frame. Cropped ends. Just glue the twine it will close all the technical mistakes on our frame. Done. You can take a decorative cord and paint our example gouache tubes. I have wood. Color stain “Mocha” The tips of the painted stained, and some just scorched by fire (turned more brutal) And with decor

Leave a Reply

Your email address will not be published. Required fields are marked *