DIY RECYCLED CRAFT: Bonsai Made Of Plastic Bottle (Tutorial)

Bonsai Made Of Plastic Bottle: Use a sharp utility knife to cut off the base of the bottle about inch above the bottom, and then wash and try the bottle thoroughly.

And so it is necessary to begin with a bottle cut into pieces. I have helped in this case, a hole punch, and nail clippers. In principle, the work-piece can be any shape, but I was thinking round.

Each piece pierces the needle (awl) and gently heat up over the fire. The main thing is not to overdo it and stop in time! Your first piece of plastic will begin to change shape and bend, which is what we need, but if you hold too long, then it starts to boil and firmly adheres to the needle, and if you hold even longer, then burn or turn into droplets and run off.

We get something that’s that. I really liked the unpredictability of the final shape and waviness.

First, I did the piece and after already collected on the wire. But when I decided to try to speed up the work.

Stumbles holes in the blanks immediately gather them to the wire and straight to her brought to the fire.

In this there is little subtlety, start warming need to fingerprints gradually moving to the edge of the wire (if you look at this picture, then moving from left to right), then you will not have the desire at some point to intercept the other end branches (because he HOT).

Everything worked out. Here everyone can decide for themselves how convenient, warm on one Circuits or collect in a twig and heat all at once.

A couple of years ago, throwing empty bottles of mineral water, I thought about the fact that I was losing something precious.

Hope you like this tutorial.

Source: stranamasterov

We would love to hear your thoughts in the comment section below. And be sure to like us Facebook for more ideas!

Thank you for visiting our website. Keep Creating with Art & Craft!

Leave a Reply

Your email address will not be published. Required fields are marked *